Release Cage Portal

This release cage portal was designed for rehabbers to mount to their release cages and easily let the little ones out when the time is right. Mounts easily to hardware cloth wire or other thin wired cages, even DCNs if you can cut the wires. It is easier to set up with two people but can be done with one.

Simple steps:

• Cut hole in your hardware cloth slightly larger that hole in the portal. Make sure no sharp points are exposed.
• Put the outside piece with the swing door on and thread the bolts through.
• Slide the interior piece over the bolts. This is where two people are helpful, depending on where in your RC your portal is.
• Attach the wing nuts and washers and tighten.

Metal guards are limited at this time.

Shipping including via UPS.